photos needed for c15a wire 3 van body
 

Looking for photos of inside the c15a wire 3 van body to help restore the inside, most of the wood paneling is gone along with just about everthing else.
Cant seem to find any photos short of the one on the fellow who sell cmp parts in Holland.

Also was wondering if anyone has a template to make the window inserts for the 13 cab.

Thanks jason

Rear window slide profile
 

Jason,
This is the profile I used a couple of years ago. I was lucky to be able to borrow the slides and frame to make copies as the rear of my cab was almost non-existent.
The square end has holes to rivet on a felt sealing strip.
The strips on the side edges and the hand grip are spot welded to the plate.
The hole near the corner is not part of it, just to hang the profile up.
Good luck with the project.
Regards, Terry

Thanks Terry, I ment the side windows that have a metal frame and are covered with clear plastic..My mistake should have been clearer...Thanks just the same as thats going to be another project sooner than later,almong with trying to find parts for the roof hatch.

\Jason

WIRE-3 (GS type wireless body) or WIRE-5 (aluminum house type body)?

Ummm It is made of aluminum body, bare with me as this is all new, I have been doing jeeps for the last 20 years,I found some photos on here of one the same from a guy by the name of mike timocheck...I know i dident spell the last name right, I think he lived down on this end of the country about 8 or 10 years ago.
Jason

Here's the link to Mike's pics.
The attached pics are from Gregg's Military Vehicle Profiles.