12 cqb engine cover
Require RH (interior) engine cover, w/wo hole for sparkplug access
|
Must be getting lonesome....
....with nobody replying to your enquiry.....
Cab 11 and cab 12 engine covers are hard to find and even harder is the right hand panel..... that usually gets taken off for maintenance and never gets replaced...... Your best bet is to contact Phil Waterman who has made a replica of that same panel..... in fact he has reproduced the whole thing. He should be able to send you some drawings of the size and bends required to fabricate your own. The you can decide if you want the sparkplug access panel or not.... Good luck and if you do make one post some pictures.. Bob C |
Your the second person who needs that drawing
I've been looking for the drawings or in this case full size templates of all the bits and peaces and how to fabricate the side panel. I’ve found all the templates but I trim the parts to fit to much to be of much uses. But I still have both of Bobs panels on the bench next to the one I made so I will sit down with the CAD and see if I can’t come up with a set of drawings for making useable panels. As you can see on my web page http://canadianmilitarypattern.com/SheetMetalWork.html the panel that I made is a good fit but is not an exact copy as I did not have the tools to make up some of the compound curves which were made by stamping the parts.
|
Is this for a Chev or a Ford? I think I've got a spare panel for a Chev.
|
I was assuming Chevy
I think Bob and I are talking Chevy, good point of clarfication.
|
side cover
Finally found a nice side panel, worth fixing and installing, big thank you to the MLU.
|
Persistence ...persistence....
Patience pays off..... you should be able to bring this one back to original......
Don't forget to post a picture of the panel when all cleaned up.. Bob |
All times are GMT +2. The time now is 18:57. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016