Vickers toolkit bracket dimensions required--LP2
4 Attachment(s)
Hi all,
I am after the dimensions for the Vickers MG toolkit bracket that goes on the floor betwenn the seats in the front of a Australian LP2. I have the rusted remains to go by; however, I do not know how high the skirt should go up around the leather toolkit. The base is 8"by 4 1/4". Dimensions and any good pics also appreciated. |
Darrin
I just measured mine and it is 2 3/4" inches from the top of the base to the top edge. This is the outside measurement as there is a lip on the bottom edge of each side that is folded to the inside. Apologies for no photo. :cheers: Peter |
5 Attachment(s)
Hi darrin, let me know if you need more.
Colin. |
Thanks
Thanks Peter and Colin for the speedy reply, I can now use what I have and your measurements to make up a bracket assembly for my project.
Hopefully others can utilise this info if they require a bracket. Thanks |
All times are GMT +2. The time now is 09:43. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016