WANTED - Rocker/valve cover for 216
 

Need a cover for my C8s lump, anyone have one available for sale?
Ideally uk as need asap.
Many thanks :note:

Colin, you'd better specify whether you're looking for the one with the slits in the top or not. The early C8s had the slits and when they went to the positive crankcase ventilation they were eliminated. My Cab 11 C15 has the slits but the C8 doesn't.

216 Valve Cover
 

Hi Colin

The Valve Covers off any Chevy from 38-54 basically with minor differences on where the oil filler tube is located. The Pat 11 and 12 have the oil filler tube at the front while the Pat 13 has filler located at the rear. Most if not all the civilian ones have a different filler hole located at the front. There are also civilian ones that have no filler in the valve cover and these are obviously good ones to convert for CMPs as with no holes you can put the filler in the proper location. I have seen various filler neck units used on CMPs the earlier ones look to be the section top of the civilian oil filler and breather that is found on the starter side of the block. The other style used on the later CMPs looks to be the same as the fuel filler and cap tube.

I'm collecting photos of the different valve covers I've seen or found on CMPs and posted them on my web site http://www.canadianmilitarypattern.c...tingPage3.html

The covers are relatively plentiful in auto flea markets $10-25 USD so if you don't find one on your side of the Pond let me know and I'll look here.

The cover i had before it was liberated from my works workshop :rolleyes had the vents at the top, but if i remember rightly i was told as it was a '41 it should have the one without, would that be correct?