Engine Isolator Question
 

Carrier Family,

Did I assemble this correctly? I had to make everything from scratch, even the engine rails so I’m not sure. In the manuals I couldn’t tell if the lowest rubber part of the engine isolator should be above or below the bent part. Thanks, for the help

Stephen DeMocko
’44 MKII Carrier
So Cal, USA

I think it should be metal to metal and the rubber grommet should be on the bottom closer to the bolt head.

Steve
 

Michaels middle picture would be correct.

Got it right this time.
 

Thank you all that responded to my question. I got the mounts sorted out last night. It took a bit longer as I had thought. I had to open up the 5/8” dia hole the bolt required to the 1-1/4” hole the metal parts needed. Thanks again for the help.