Free to good home
 

Dont know if there is any interest, but I had a sort out in the workshop and found the following:

1/2" BSF Tap (16 TPI), I think its the starter tap, as the lower end would fit into the pilot hole.

1/2" BSW Die (12 TPI)
7/16" BSW Die (14 TPI)
7/16" BSF Die (18 TPI)
Barely used.

They were from stuff in my fathers garage, spanners sockets as follows:

BA sockets drivers, 2, 4, 6, 8 BA

Ring drivers, these are like a short socket but have a lug to one side so they can be hammered (not sure of the correct term)
Marked as follows:
1/4W
5/16W
3/8W
7/16W
All King Dick.

Sockets
Marked as follows:
5/8W
9/16 BSF - 1/2W
1/2 W
1/2 BSF - 7/16 W
5/16 BSF - 1/4 W
5/16 W
3/16 W


Ring spanners:
Marked as follows
1/2 W 5/8 W
1/2 W 9/16 W
3/8 W 7/16
1/2 BS+7/16 W - 9/16 BS+1/2 W
3/8 W - 7/16 W
3/8 W - 5/16 W
1/4 W - 5/16 W
3/16 - 3/16 W
5/16 - 3/8 W
5/16+1/4 W - 3/8+5/16W
1/4BS+3/16W - 5/16BS+1/4W
1/8W - 3/16W

OE spanners
1/2BS+7/16W - 9/16BS+1/2W (2)
1/2BS+7/16W - 7/16BS+3/8W
7/16BS+3/8W - 3/8BS+5/16W

Mostly King Dick, Britool, some Snap On sockets.

Good condition.

I would like a contribution towards postage be given to the MLU site.

Any takers ????

Job lot only

George.

george.dfs1@virginmedia.com
Phone: 01752227400

PM sent
 

PM sent, with compliments

George,

Earlier today, I saw you posted this message twice. One of the moderators must have removed the other posting in which you stated "UK only" or words to that effect.

But if you are willing to ship outside the UK I would be a taker.

Thanks,
Hanno

Hanno I removed the double posting

Tools
 

Sorry to say. the offer has been taken up, so they are no longer available.

They will be going to a good home, as the "buyer" has refunded postage.

Suffice to say, that certain monies will be donated to the MLU coffers.

There was a second post, apologies for that, but at my age, communication between brain and fingers sometimes get muddled.


George.