Flare Box Mounting Details
 

Can someone please help me with the details of the mounting bracket for mounting the flare box to the engine cover in the riveted U.C.
Here is a picture of the holes in the side of my recently aquired original, early flare box with leather strap. Thanks to Robin Beale for swapping flare boxes with me.

Here you go

Thanks Lynn & Jordan,

While it is a long way down the track before I even make up the armoured engine cover I do have an Aust flare box and can modify it accordingly.

I used to know where the bracket was without the flarebox but it got bulldozed a few years back...:(

Cheers

Phill

Jordan
 

Your a ripper!. Not much left to ask. I guess the width is 2.0" Thankyou for your very helpful effort. Cheers.

I'll check on the weekend about the width. As for the internals mine came from and Aussie one. It fit perfectly into my Cnd made one

Had a look in a local scrap heap where I thought the bracket had been but no luck. I do remember picking it up and wondering what needed so many rivets to hold to such a small bracket.

It may still turn up but unlikely

Cheers

Phill

a bit later on
 

Jordan, can you tell me the width please. Cheers. :thup:

Sorry for missing that. It's going to be awhile before I can get that info. Just busy with works and new house and little time to play.

Jordan, Doug has asked for the bracket info, so I have revived the thread to get the last details from you, if we can have the width please? :salute: :salute:

Doug, I hope this covers what you need. I haven't done mine yet.

Lynn,Jordan,
If we get the last bit of info. this should cover it.
Thanks to both for great info.
Doug

2"
 

5.0cm x 27.3cm or closer to 2" x 10.75"

Michael,
Thank you for filling in the remainder of the puzzle.
Doug

Thanks for posting that info.