Rear tool plate crow bar
 

Hi

Does anyone have an original spec crow bar that straps to the bottom of the tool plate?
If so would you mind measuring the diameter for me please?

Thanks

Ben

Hi Ben, I did write you an email back about this and the 7/16" lifting eye screws but my computer locked up and it wasnt sent, the crowbar length is in the manual, diameter wise it needs to fit in the retaining strap holder, I will check tomorrow on the one I have but its a shortened vintage one with a point reground, will check the counter sunk bolt length tomorrow and post it up if no one beats me to it.

kev.

Thanks Kevin,

It's the diameter I'm after to help out make the bracket for the Bren.

Cheers

Ben

Ben,
Made my bar out of 1 1/4" round bar.
Doug

Ben, i have both ends for the crow bar... the bracket that goes under the step and the spade head end... i can send them down if you wanted to copy them... they are repro but goodun's

Ben, 1" CROWBAR, 7/16 Slotted lifting eye bolts 1 1/2" shank length, measured from nos originals.

kev.

Thank you all. The Bren bracket is a little different from the UC type as there is no step on the RHS. The diameter lets me work out the size of the bottom fitting.

Thanks

Ben