3 ton jack
 

Hello.
Can any one tell me what markings are on the 3 ton hydraulic jack please, and could any one provide pictures and measurements of the handle.
Thanks Stephen

you mean this one?
it is a walker model 925,a model 927 is almost the same.

second picture is the jackblockholder including the walker 927 i made

Hello Roy
Yes that is the one. Are ther any marks in the casting on the base please.
Thanks Stephen

i have too look for it tommorow or monday.
but,what marks should have been on it?

Hello Roy
I picked up a jack a few weeks ago at a boot fair that looks like the right 3 ton jack but has a slightly different top. The only marks it has are hard to read but look like WH553 at one point and a 5 at another. There is a bit of green paint left as well. It is just over 10 and a half inches tall. I would be pleased to know what you think.
If you think it is OK, Ross said that you recently made a base for yours, would it be posssable to give me some measurments for it please.
Thank you very much, Stephen

Hi Stephen, Search this thread : 'mk1 canadian carrier jack block'
on this forum.

kevin.

Thanks Kevin
Will look for it now.
Stephen

stephen, i get the measurements indeed from the carrier block post.
what is different on your jack top?
as said i fitted a walker 927, it is almost the same than a 925,only difference is the location off the modelplate and the lifting plate on top is smaller.
i have also a walker model 930,but from this one the baseplate is about a half inch wider.