CMP Lamp internals
 

Hi guys.

I need to replace the wiring on some of my lamps.

Any source for or tip for what to use for replacing the crimp on bulb connector at the end??

http://www.surfacezero.com/g503/uplo...240213_020.jpg

Svenn

Try Rhode Island Wiring Service
 

Hi Svenn

Take a look at http://www.riwire.com/ check supplies and then look at Washers, Buttons,and Screws.

http://www.riwire.com/Catalogs/sup/pics/ButtonSmall.JPG

Cheers Phil

Bare about 1/16 of an inch of wire on the end of your new wire, insert through a suitable size small flatwashr, bend outwards the strands, and solder them to the flatwasher. If you were to pre-tin the washer, it would solder together easily, but should work either way. Of course, use rosin core solder, and not acid core.

For new fiber washers and springs, you can salvage them out of more modern lamp sockets.