MLU FORUM

MLU FORUM (http://www.mapleleafup.net/forums/index.php)
-   The Restoration Forum (http://www.mapleleafup.net/forums/forumdisplay.php?f=17)
-   -   12v to 6v conversion for Cab 12 (http://www.mapleleafup.net/forums/showthread.php?t=21479)

TCLARK 02-01-14 01:09

12v to 6v conversion for Cab 12
 
3 Attachment(s)
I just put in a 12v to 6v electronic voltage reducer and regulator. This unit was purchased on ebay and will enable you to use any load such as gauges , lights or anything else up to 20 amp with a constant regulation of 6.8 volts. I installed this on my oil pressure guage and my fuel tank gauges and they work perfectly. I could also hook up some dash board lights etc as long a s I switch them on a different circuit than the 12v headlights. This system works better than putting in resistors. Please excuse the wiring mess as I have to tuck everything into looms
Terry

Bob Carriere 02-01-14 03:58

Fantastic job.....
 
You should have been a brain surgeon....

Nice job.

Bob C


All times are GMT +2. The time now is 17:31.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016