![]() |
Bedford instruction plates.
1 Attachment(s)
Hello,
I have has a batch of instuction plates made for the bedfords. Fitted to MW, OX, OY, and QL available in two finishes as shown. Proffesionaly printed on aluminium. Attachment 69108 £15 for any of the small pates, and £20 for the big bedford chassis plate. plus postage. |
Nice! :thup2:
H. |
Quote:
regards hans |
Plates for hans
4 Attachment(s)
Hello Hans,
You should have, one choking plate on the dash board, one coolant drainage plate on the steering collum support bracket, and the smaller chassis plate on the bulkhead. For the coolant drainage and the choking plate either black or white is ok, there was no particular order to the colour just some were black and some were white. Attachment 69126 This is the early dash in my truck, but the choking plate is in the same place on later trucks, sometimes in the middle, or the other side above the choke, but always at the top. Attachment 69124 Attachment 69128 The drainage plate on the steering collum Attachment 69125 Where the red plate is in this truck, the chassis plate should be. The plate below it is the lubrication plate, my next project once i have sold a few of these. Have a look and see if you can find the holes. Hope that helps John |
Quote:
i an take a look tomorow of i can find some holes in my bedford maybe i wil order a set of the plates hans |
All times are GMT +2. The time now is 09:22. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016