![]() |
LP2 ia intake tubes
5 Attachment(s)
I'm not sure where to put this thread so it could be merged if need be. I thought there was a thread on making parts somewhere.
Anyway , I had to stop the Vickers for a short time to make some intake assemblies. The tube is not available as it is a specific size. I assume to be the inside dia of the rubber joiners.2 1/2". I have made these all by hand apart from bending the tube in my hand bender. |
5 Attachment(s)
I certainly won't be making a lot of these things:blink:
|
5 Attachment(s)
Angle is very important so it does pay to have an original
|
5 Attachment(s)
I'm only making 2 sets at the moment
|
5 Attachment(s)
I wish I could make them as quick as I can post them. :salute:
|
Still have a set
Hello I have a LP2A and was wondering if you had a set available or still making please
|
All times are GMT +2. The time now is 01:15. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016