![]() |
Ziebart Plate on M151A2
Does anyone have a photo of, or know where the Ziebart plate was placed on M151A2s? Did these often survive, or were they commonly painted over?
|
M151a2
2 Attachment(s)
Here are a few, found on the Interwebs from unrecorded postings.
|
Zeibart plates
Unless you have the holes drilled in your windscreen, it might not have had the post delivery Zeibart applied.
Mine did not. Thanks Eric |
Eric: Perhaps your windshield frame was replaced at one point? Or perhaps yours was just glued on rather than rivetted? I think the ones around here were just glued but would have to check the pile of windshields out at the scrapyard. They were very very judicious in making sure all the M151A2 fleet was done. I remember them being sent away when I was militia. When I went regular force and was on my TQ3 training in Borden (1981) they even sent in the training aids for re-application of ziebart. It made a real mess of the hands and the crappy swarfega mechanics soap we were issued back then was no match for the ziebart. A dip in the solvent bath would make short work of the ziebart mind you.
The dirty hands.....23 years in the 411 trade and you kind of got used to that. I think I am starting to ramble a little bit. :coffee |
All times are GMT +2. The time now is 16:52. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016