[Big D]

Gidday folks,

Thanks for the replies.

cletrac - yes, I am not familiar with the resistors at all so couldn't say for sure whether this is the right type. The voltage does appear to be stepped down correctly but it is how it is being done that has me curious.

Pedr - I have looked over the circuit diagram in the workshop manual and I don't see any link as such between the inspection lamp and the resistor. I will check the voltage across the inspection lamp switch with the igntion off and see what that is. That might help to narrow down what is going on. I'd be interested in what you thought though after looking at the circuit diagram.

Cheers.
Darryl