View Single Post
  #8  
Old 23-09-08, 10:35
Big D Big D is offline
Darryl
 
Join Date: May 2008
Location: Dunedin, New Zealand
Posts: 661
Default That little resistor...

Gidday all,

Thanks for the replies. Yes, I reckon you are spot on with the resistor being the wrong type. I did some more measurements tonight with the voltmeter. With just the ignition switch on, the voltage is 6.1 volts on one side of the resistor and 1.63 volts on the coil side of the resistor.

When the inspection lamp switch is turned on (without the inspection light plugged in) the voltage on either side of the resistor is 5.87 volts and 5.45volts.

Somehow it still seems to drop down to 4.2 volts at the coil but I am unsure how.

As you all say I need to get the correct resistor and remove the little hotwire from the inspection lamp switch and that should do it.

I'll try Ajays Rob.

Thanks all for the help.
Reply With Quote