Quote:
Originally Posted by listerdiesel
We have got another set of these wheels, this time from an ebay seller down near Bristol, the auction was pointed out to me by one of the guys on our own forum.
They are British, cast 'JM 1941' and the tyres are "Avon 1944", bearings are Ransome & Marles 4HJT40.
Tyres are better than the ones Kevin had from us, but the bearings are so much scrap. One wheel must be an idler as it has bronze bearings instead of thrust ball bearings.
We intend to use these, but can offer the seal retainers and bearing spacers for free to anyone who wants them, collect or pay carriage.
The bronze bearings have got four tapped holes in the face, are these for an extractor or do you screw setscrews in them and push the bearings out?
Also, on another thread, the bearing 6204 is mentioned for carrier wheels, but these are tiddly compared with these that I have here, is that a mistake? is there a modern compatible bearing?
Peter
|
Hello Peter, you are right, the number should be 6408
, your bearing are the same as I found in my wheels, they are a bit ofset, to let my sealings run free I needed some shimms, take good care to the bushings between the bearings, they were the major problem to me, you need them when you change from plain bearings to roller bearings and I had more plain than rollers.
Hendrik van Oorspronk
