Camplate and clevis
Gidday Lynn,
Yes, the view I have shown in the photograph is (via the mirror) looking back along the floor of the hull, through the bulkhead in the drivers area, looking back at the clevis on the camplate. You can make out the camplate in one of the two pictures I posted.
In the picture you have posted, it is the left side clevis mounted on the camplate (labelled J) that is the problem.
The problem is that once this clevis is fully back (toward the rear of the carrier) it drops below a plate that is bolted to the hull around the area where the cross shaft goes.
As you say, it is simply a little too close to the floor. I would say it would only need 1-2 mm shaved off the underside of that clevis (or off that plate) but the problem is getting too it, so I could remove the clevis mounting screw.
Does that help explain my predicament?
Cheers
Darryl
|