[Bob Carriere]

Hanno

...I had not realized that you were so small..... and to think I said the tranny was VERY small for the truck size....

...if I ever need my watch repaired I will send it to you hahaha..

Nick

Thanks for the good news..... I am hoping that I will find a patient and preferrably older parts man at the local General Bearing Services who will be able to source the bearings..... I do not remember seeing any seals... would it be on the tail shaft where the u-joint flange fits???? it might still be inside the back cover which I have not washed yet.....

I am hoping to do the same on the transfer case.

Those anyone have North American parts number to share???

I will make a point of posting whatever after market parts I use.