Cdn m151a2 Door frames
Hello Dave,
There are two types of door frames used, Canadian type and of course the U.S. type, going by your picture you have the CDN modification done.
You can see on the body side down by your foot area, a small flat plate with a short piece of pipe welded to it, then bolted with two 1/4 inch bolts. This is were the original verticle rod pocket was. The CDN door frame uses two CDN made brackets one bottom the other on the top.
THE BIG DIFFERENCE in the CDN made door is there one piece welded frame ( I have two of these ) and has a deeper inside handle to go around the CDN roll bar. The U.S. type is kinda neat, It folds up to put it away for storage but can be wobbly while on the jeep and not very ridged. You also need with this type 2 verticle rods at the rear of the door to keep the door closed. I have both types so I could take a photo for you.
I dont have spare CDN frames but I have new door skins as well as side curtians , If your intrested ?? I just have to find them ......
Like I mentioned I could send a few picture's your way.
Thanks Paul, CDN M151a2 owner
|