View Single Post
  #8  
Old 12-01-10, 02:25
NORTH-SHORE(CANADA)'s Avatar
NORTH-SHORE(CANADA) NORTH-SHORE(CANADA) is offline
Registered User
 
Join Date: May 2007
Location: Tracadie New-Brunswick
Posts: 522
Default

Quote:
Originally Posted by Alex Blair View Post
Use silfos, or silver solder(low temperature)..Install a drain on your storage tank..auto blowdowns are available...
Your air inlet on your compressor usually has an air filter on it..Take it off and pipe your air inlet outside and then re install your air filter outside..where it can draw relatively clean air..It doesn't matter how clean you try to keep your shop your air compressor will eventually draw in grit,paint fumes gasoline fumes and all sorts of obnoxious crap which will kill your compressor in no time..unless you pipe your air intake outside..Don't forget to put a vibration eliminator on your air inlet line..
Good luck..Install auto blowdowns on your drip legs and you are away..
Hi,
I did have one on my compressor and i did instal a auto blowdowns at the end of my systeme went i install my regulator it came whit 2 gauge and a auto blowdowns it came frome a hold campbell compressor like the pic
__________________
Eric Thibodeau
1942 willys Jeep
Reply With Quote