Hi Kevin
Ok got the holes measured up
Going from the back steel plate towards the front. The first hole is 4-1/4" to its center. The second hold from the back plate is 15-1/2 to its center.
The are 7/8 in from the inside edge. I can't remember if it was the center of the hole or not. However the holes are offset to the outer edge.
The hole diameter is 3/8"
Hope that helps.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
Last edited by Jordan Baker; 16-01-10 at 16:56.
|