[Eric B]

Hello Folks

Both of my jeeps were Signal Squadron vehicles.

M151A2- 1 Mechanized Brigade Group Signals Squadron. Then shipped to Petawawa at the end of its life.

M38A1 CDN2 - 2 Mechanized Brigade group Signals Squadron, then at the end of its life assigned to Kingston Signals. It was used as a test platform for some radio equipment, but i don't know what.

By chance does anybody know what 2 Mechanized Brigade Group Signal Squadron would have had for markings? There was a white over blue square on my M38A1 but i did not see any number. I am not sure what the Brigade Group formation sign looked like for the 1970's. ( Pre TAC)

The same would be for the TAC sign on the M151A2 and if there was a Brigade marking applied to these vehicles. (I know the basic Signals TAC sign).

I am looking for

1) a non functioning Nestor KY-38.

2)Several cables and vehicle battery cover (hyp-57) for the ky-57.

3) Installation Instructions and manual for the KY-38 and the KY-57

4)Brush Guard 5820-21-849-3203 or
base assembly antenna 5820-21-849-3202. These were used with the MX-2799, opposed to the more common MX-6707 AMU.

5) Support bracket assembly 5820-21-847-3343. This is the special plate that the power tray was mounted too.

I also have a Vinson KY-57 for trade for an Amplified Tray am-2060.

Thanks

Eric