View Single Post
  #1  
Old 26-03-10, 12:50
lynx42 lynx42 is offline
Rick Cove
 
Join Date: Jan 2007
Location: Paynesville, AUSTRALIA
Posts: 1,866
Default Parts needed for LP2A

I've just started on carrier LP2A number 2250 built by Victorian Railways Workshops, Newport, Vic.

This carrier was purchased after the war by the Tocumwal Gliding Club. They remover all the running gear to make a glider launhing winch. The remains were stuck up the back of the airfield with nothing much else removed. Of course the obvious missing bits are as follows.

V8 Engine,
Oil cooler and relief valve,
Fuel Tanks (2)
Fuel tap (3way)
Aircleaners,
Aircleaners to carby Ducts.
Gearbox,
Gearbox linkages,(Wishbone, fork etc)
Coupling,(To Diff - keyed type)
Tracks,
Bins (All of them)
Headlight(1 needed),
Taillights (2)
Engine box side plates (Left and Right sides)
Oil Filter(Fram)
Frame shutter (Driver)
Back rests (both driver and gunner)
Tools (All of them)
and many other little bits.


If you have any of these parts, I would like to hear from you.
Thanks Rick

See this thread for the recovery story - Still they come out of the woodwork
Attached Thumbnails
BrenCarrierlong%20088a.jpg   170308210ab.jpg   BrenCarrierHowlong%20037a.jpg   BrenCarrierlong%20114a.jpg  
__________________
1916 Albion A10
1942 White Scoutcar
1940 Chev Staff Car
1940 F30S Cab11
1940 Chev WA LRDG "Te Hai"
1941 F60L Cab12
1943 Ford Lynx
1942 Bren Gun Carrier VR no.2250
Humber FV1601A
Saracen Mk1(?)
25pdr. 1940 Weir No.266
25pdr. Australian Short No.185 (?)
KVE Member.
Reply With Quote