[ron]

Hi Alex, just grabbed the first piece that I could, the pics show both ends and sides,along with the number4 on this piece and the makers name Malco,I forgot to mention that on the inside of both of the horns there is a small area that is rased with the letter A and 43,( Aust and the date I would think) these plates must have been attached to the original patterns and are approx one and a half inches long by about one quarter of an inch wide, you can even see the slotted heads of the screws used to attach them,says a lot for the quality of the workmanship in the foundry,hope the pics are of interest, I will dig out some better track if needed in a couple of days,
Regards Ron