Quote:
Originally Posted by Lynn Eades
It would be good if you can run a few photos of the process. no doubt it will help a few people who havent done theirs yet.
|
Thanks Lynn,
Bruce pressed a bogie assy apart which was a a tough job and required plenty of heat too. Then he soaked a spring assy in citric acid bath for about 3 days and that cleaned up everything except where the balls were rusted to the rod. So then he tried pressing and also resorted to a lot of Oxy to heat the ball up trying to not get much heat into the rod or springs. Heating and cooling didn't seem to break the 'hold' of the rusted interface but finally his press got it moving and apart. He repeated for the ball on the other end of the rod. So this method got one spring assy dismantled and I'll post the job in two lots. The sandblasted and primed pics I'll put up soon.
Regards
Alex