Hi Tony,
Did you use any sealer on the face between shaft and hub? I know silicone is popular now, but I avoid it on places like this because it tends to go off before you get the flange up tight and you end up with a thick membrane of silicone and this would allow the two parts to fret and shear the studs.
Just a thought anyway.
regards, Richard
__________________
Richard
1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2
Member of MVT, IMPS, MVG of NSW, KVE and AMVCS
KVE President & KVE News Editor
|