Plan Z would perhaps be just get the edges arounnd the areas you want to weld, if its just a small area most compressers will have sufficient CFM to power a cheap blaster unit from say "Clarke" or somewhere. Saves getting someone out or transporting the hull. Then once your ready you can get the entire hull done. you can also get some fantastic metal prep solutions, just make sure you rinse and then run a blow torch over the areas treated before you Mig it or you may poison yourself and the welds wont stick
__________________
is mos redintegro
__5th Div___46th Div__
1942 Ford Universal Carrier No.3 MkI*
Lower Hull No. 10131
War Department CT54508 (SOLD)
1944 Ford Universal Carrier MkII* (under restoration).
1944 Morris C8 radio body (under restoration).
|