[Bob Moseley (RIP)]

Hi Scott - looking at your images of the switch plates I am not sure whether they are correct. You need to remove them to see if my attached image fits.

The switches you are asking about, I am on my second box of fifty. Again look at my switch image where you can see five out of the six are Off/On switches whereas the Gas Switch is an On/On switch that took me over a year to source. There are plenty of On/On Bat Handle toggle switches but not Ball Handle. I have also replicated the small switch plates. I have a couple of complete sets left but then I am out of the On/On switch until I can find some more. On the other hand if you require the large switch plates, I have provisions for those as well. The only difference with the old and new switches is that the On/Off toggle does not stop in the centre. It rests above and below centre respectively.

Bob