1946 Chev and Ford Wasco Dizzy tool
You meet the stangest and micest people when looking for possible CMPs....
Right in the village of Hammond we have a guy wo does a lot of work on old flatty Fords.....
I took some oics of a 46 chev.....same body as a 42 staff car...... last ran in 1957....some one took a wheel bearing off the front axle and a few years later the engine/tranny came out...... but could be converted to a staff car if one was so inclined....asking $500 ........ would be worth while negotiating.
Hew also dug up the specail tool for setting up the points on a Ford flat head.... made by Wasco..... forgot to ask what he wanted for it.... he has another one plus a floor mounted Allen dizzy set tool with special Ford attachements for it...... not yet ready to sell that one.....
I have no personal interest except to share with fellow CMPers.....
Also found what I went there for..... complete early 235 with ribbed valve cover.....Bellhousing to fan, carb, starter, generator..... that one will most likely stay with the barn......
Contact me for his tel. ### you make your own deal !!!
Bob
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
Last edited by Bob Carriere; 25-09-11 at 03:43.
|