One more question?
Hi carrier folks. I had some success in fabricating my accelerator jack shaft thanks largely to the information Lynn posted above. I have one more question though. My carrier project did not have a bulkhead when I started. I made mine with pictures and dimensions I received from other forum guys. After going through the thousand or so pictures I have collected over the last couple of years I don’t seem to have a single one that shows where the accelerator push rod goes through the bulkhead. I have a rectangular slot next to the round hole for the hand start handle but do both the clutch rod and accelerator rod both use it or am I missing a hole? Any pictures and greatly appreciated and thank you all for the help.
Stephen DeMocko
’44 MKII
So Cal, USA
|