Quote:
Originally Posted by ajmac
I haven't got one to hand at the moment, so could anyone give me the details of the box spanner required to remove the large hub retaining nuts and the recomended way to side out the locking plate. Also why is the locking plate so complicated, modern hub nuts are normally locked in place with a tab washer, so cheap and simple!
|
The lockplate should have U section ring around it, this is to stop oil migrating from axle to hub. It can be withdrawn by screwing in a couple of screws in the tapped holes and easing it out. The eight sided hub box spanner, I forget the size, but mine was bought from a motor factors a few years back, do a search on Ebay, etc for Melco hub spanners.