Hi Jordan, I swung in a 24 stud canadian engine into the mortar carrier today. Your downpipes will fit, What you need to do is remove all four cast elbow 5/16" floor bolts, check you have the correct size gasket on the cast elbow floor flange, put in four descent bolts & nuts and leave them slack, Bolt your downpipe to the exhaust manifold up tight with the correct gasket, then tighten the four floor bolts, everything should pull into position.
I couldnt bolt the downpipe to the exhaust maifold as the bolts are sheared off in there. How are you sealing the down pipe to the floor casting?.
let me know how you get on.
kev
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008.
3" Mortar Universal Carrier 1943 registered 06/06/2009.
1941 Standard Mk1 stowage Carrier, Caunter camo.
1941 Standard Mk1 stowage Carrier, light stone.
10 cwt wartime mortar trailer.
1943 Mk2 Daimler Dingo.
1943 Willys MB.
1936 Vickers MG carrier No1 Mk1 CMM 985.
Last edited by kevin powles; 22-03-12 at 21:05.
|