Two small holes should be drilled at both ends of the crack to stop it from spreading, then stick welded, this is a comon place on GPW blocks as its a thin area. Alot of Gpw blocks that crack in that area will also crack in side the distributer shaft hole,if so this area can be fixed also but will need to be machined out and a sleeve installed, but there will be oil / antifreeze showing on your dip stick or PCV valve if this is the case.
Jason
__________________
42 Slat grill
43 Ford gpw
44 C15A Wire 5
Last edited by cliff; 20-06-12 at 03:46.
Reason: corrected spelling mistake
|