front panel in
Ground down the edges of the replacement front panel and welded in 2 support braces behind where the panel will sit. Fitted the panel, adjusted the braces, braces fell out, re-welded them back in, re-adjusted until I got a nice fit. Discovered that the front armour plate has a slight bend in it, I wonder if this is why a section of the front panel was removed? Previous accident or did it bend from the cutting????
Placed some tack welds in and then used the bottle jack behind the panel to move/lift it into place until the outer surface aligned. Then started to weld it in for good.
The pics show the process from start to finish, it may not appear that much is happening in them, but there is approx 8hr of work there...still have to place some welds in behind the panel yet.
__________________
1943 Ford GPW Jeep "Follow Me"
1943 MBT trailer
1943 Dodge WC-57 Command Car
1943 Chev C60L Army Cargo Truck
1941 LP2 VR 731 Bren Gun Carrier 3" Mortar Carrying
Under restoration:
1940 LP1 Bren Gun Carrier
194? 1 Ton Trl Ben Hur
1942 C15A with sunshine cabin
MVPA 31338
|