Well finally going to get to it...maybe today. weather is nice and sunny too so...
have to ask rob torquing the four bolts for the seal/speedo gear housing 30 lbs or 25 to be safe...should I put anything on the shim pack...to seal it on the block or housing itself before bolting it on?
Also the torque of the companion flnge that holds the brake drum...it was not that tight to begine with so tighten it up as before or torque to the same as the yoke...175 ft lbs?
Hope you are doing well and the 6x is keeping you busy!
Casey
__________________
M38A1 CDN 53-32490
|