Engine rotisserie- Another variation on the theme
Here's another one.
I really get annoyed when I see pre 1949 Ford Flatheads on Ebay for sale being held only by the bellhousing in a modern engine holder. That's a real good way to turn a great engine into a boat mooring anchor.
I had this made up a few years back. Again, apologies to the Ford CMP Maintenance Manual for borrowing their ideas.
It worked well. The balance point was good so that you did not need a gorilla to rotate it.
Only trap if you fabricate one yourself is to offset the left pivot pipe about 1" further back from the front than the one on the right. This is because the left cylinder banks is about 1" further forward than the right bank. I have the exact amount written down somewhere but cannot seem to put my finger on it. No doubt that info is out there somewhere on the net.
This offset is noticeable where I bolted the brackets together for storage.
Cheers!
__________________
F15-A 1942 Battery Staff
Jacques Reed
|