[Phil Waterman]

Hi Guys

First I don't think the hook incorporated into the spring shackle was intended for use with the winch or winch scotches it is to lightly built. The U attachments for the scotches are much much heavier 3/4 to 1" diameter and they need to be.

I've attached the scotches drawing from the hand book as well as some pictures of the scotches on my truck. The pictures with the cables were taken when I was getting the correct length. Since then I've had heavy cable with loops made. Strangely because of the placement of the frame hooks the cable chain combo need to be different lengths depending on you are put them under front or rear wheels.

I've used the winch and scotches a lot for pulling very large trees up hill. The winch unit is amazingly power full and deserves respect. When you put the scotches down on the ground and hook them to the frame hooks and move the truck wheels up on them and then start pulling, because of the scotch angles they dig right into the ground until flush.

Now to the wheel flanges the explanation I was that they were primarily to speed ship loading and unloading using a pair of spreader bars equipped with loop ends a crane crew could very quickly have a truck read to lift. The other use of course is using two ropes they can be used like a capstan winch to pull a vehicle out being stuck. But if there was mud involved I'd drag at the regular winch cable first.

Cheers Phil