Quote:
|
Also received these two NOS exhaust hangers. One will make a reasonable copy of an original with some reworking. The other may not get used. Depends on how close to original I want to go.
|
This may be of interest:
Here's a photo of what I am 99% certain is the rear muffler to chassis hanger for Ford CMP trucks as I have seen the same on three vehicles this past week. Still, I have been wrong before here. I am in the process of straightening it out, but with the extremely hot weather here I do not want to fire up the "blue tongued lizard" (oxy-acetylene torch for non-Australian readers). No use scaring the neighbors!
Bending steel cold can only be done so many times before it snaps and it is not worth stuffing it up.
It mounts 6" behind the face of the transfer case cross-member in the lowest hole in the frame rail.
I am thinking it is the same dimensions, minus the bends, as the hard to find tailpipe bracket that attaches to the left rear fuel tank bracket. it is 1/16" thick, 1-1/4" wide, and 9-1/4" from the center of the clamp to the end.
Can anyone confirm if it is the same? If so, I will use it as a pattern to make that bracket.
Cheers,