Quote:
Originally Posted by Tony Wheeler
Yes, after searching the net I don't think they're worth fabricating, so there's probably not much point making drawings - which is good news for Jacques!
Closest I've found is this $30 kit which contains 3 brackets, all of which could be used with minimal modification and be undetectable as non-original:
Jacques, I imagine these brand new brackets may change your plans a bit so I'll leave the old rusty ones where they are for the moment!
|
Hi Tony,
Thanks for your information. I did buy a Dennis Carpenter exhaust bracket set a while back but there was not enough length on the longest one to make the bracket that attaches to the fuel tank bracket as shown in the photo.
Yes, thought about the adding a length of flat bar to an existing clamp in the set but forgot about the asymmetrical design too. Good spotting. The set did give up a good old design 2" muffler clamp when I wiggled the poorly spot welded clip attached to it shown in the centre of the photo. Thank God for Dennis Carpenter's poor Chinese made stuff. Saved drilling out a spot weld!
Will check out the supplier mentioned.
When you get a chance Tony would you be kind enough to give me the dimension between the centre of the bolt hole on the clamp to the centre of the first hole where it attaches to the fuel tank bracket then I can work out the length and see if their bracket will do the job. Many thanks again for all your help and a great afternoon with the trucks.
Cheers,