View Single Post
  #1024  
Old 14-03-13, 02:18
Private_collector's Avatar
Private_collector Private_collector is offline
Tony Baker
 
Join Date: Oct 2010
Location: Wide Bay, QLD, Australia.
Posts: 1,819
Default Grant

Yes, that's a very good point.

I think there is such an item which may require lube, on the input end of MDG, under throwout shaft. I will need to look closely at this tonight. From memory, it is a brass collar. May be able to do without it now that bearing is sealed? In fact now that I think about it, that collar nay have been output end. I'll see tonight. All the parts are layed out on floor, in an exploded diagram way.

Is it difficult to remove the seal from a bearing? Just in case I have to do it for whatever reason.
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still)
Medium sized, half fake, artillery piece project. (The 1/4 Pounder)
Reply With Quote