[Gordon Yeo]

Bob and David

I took a close look at the wiring harness today, looking for metal shielding. There is no engine in the truck so I am guessing at the connecting points of the wires I looked at. I found two shielded wires, one would go on the generator and the other, as Bob suggested, went from the dash down to the frame below the drivers seat. Possibly connects to the starter as a feed for the power source. These appear to be the only shielded wires in the wiring harness.

Phil

Thank you for the heads up on the insulation, I certainly don't want to end this story prematurely. As I removed the paper insulation it went into the shop furnace, it burnt with a lovely bluish flame.

Thanks to Neil for posting the pictures, nothing too startling, just to show something is happening here.

Gord