engine bay divider plate goes in
After painting several coats of green in the engine bay where the tube axle goes, it was time to put into place the engine bay divider plate that I had measured and lazer cut.
It is possible to have the plate in and then fit the fuel change over linkage rod, but I decided to fit the linkage first and then weld the engine bay divider plate in over it. Later I will get the bolts and brackets fitted to secure the linkage so that it does not fall out.
Also started welding in the metal brackets/guards that protect the brake rods running to the rear of the hull.
__________________
1943 Ford GPW Jeep "Follow Me"
1943 MBT trailer
1943 Dodge WC-57 Command Car
1943 Chev C60L Army Cargo Truck
1941 LP2 VR 731 Bren Gun Carrier 3" Mortar Carrying
Under restoration:
1940 LP1 Bren Gun Carrier
194? 1 Ton Trl Ben Hur
1942 C15A with sunshine cabin
MVPA 31338
|