View Single Post
  #1192  
Old 04-10-13, 02:21
Jacques Reed Jacques Reed is offline
VMVC
 
Join Date: Jul 2012
Location: Victoria Australia
Posts: 864
Default Ford CMP original engine exhaust pipe

Quote:
Originally Posted by Tony Wheeler View Post
Here's a pic of the original set up Tony. It's handy having a few reference vehicles in the back yard! I believe the bend in the RH engine pipe is to prevent it fouling the diff housing, just like the cutaway in the front crossmember. However it sounds like yours passes even further back near the drain plug...?
Hi Tony W and Tony B,

Just catching up on reading the MLU posts.

I have attached photos of what I believe is a section the the original exhaust pipes at the engine. This was attached to my vehicle but had been cut off short and a new section added to the rear to the muffler by the previous owner. Interestingly the new section was 2" pipe swaged to fit over the remnant of the exhaust pipe and it too kicked downwards as it does in Hannos's photo and the photo I posted a while back of an original one at Bandiana Army Museum.

It seems to concur with Tony Wheeler's photo and Hanno's photo of the entire pipe.

The crossover clamp is the same as used on Jeep exhausts so is readily obtainable.

Hope this is of some help.

Cheers,

Jacques
Attached Thumbnails
IMG_0016.jpg   IMG_0014.jpg  
__________________
F15-A 1942 Battery Staff

Jacques Reed
Reply With Quote