Go to my thread "Control Rods Riveted U.C." It tells you how long and how much thread. Do them on a lathe (rod in the chuck and carefully supported) Square the die stock with the tailstock. The rod is medium tensile 7/16".
Both sides are the same length.
To do your lower engine rail, it would help heaps if you can borrow one.
Does this pic help? (It is an AOP sorry)
__________________
Bluebell
Carrier Armoured O.P. No1 Mk3 W. T84991
Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6.
Dodge WC55. 37mm Gun Motor Carriage M6
Jeep Mb #135668
So many questions....
|