Well got a bit more done today, this time the gunners left hand side folding armour I had to bend up a small joggle that catches the retaining latch from the front armour, which pretty much consisted of cutting a strip out of a bit of scrap 8mm steel then bending it to the required heights, followed by fixing it to the plate with two 3/8 rivets. Next I had to rivet on the spall strip which was used to catch any fragments of bullet should a round or two strike the armour where the fold down section meets the main plate..... This was fixed with five 5/16 rivets, two of which had to be ground flat afterwards to allow for the hinges to sit over them...
And here we are ready to rivet onto the hinges ! Tomorrow's job !!!!
