View Single Post
  #3  
Old 21-06-14, 01:51
Phil Waterman Phil Waterman is offline
Moderator
 
Join Date: Feb 2003
Location: Temple, New Hampshire, USA
Posts: 3,929
Default Question about telling Pat 11 from Pat 12 Cab Frame

Hi All

This post is in response to a question asked by Alex van de Wetering who happened to send me a message asking about part numbers or a way of telling Pattern 11 from Pattern 12 Cab Frame.

His message came in the day I was swapping out cab frames. I have not found any part number stamped on the cab frames. But it occurred to me that one of the major differences was Pat 12 have a hinged hood so the holes for the hinge and there location should be a give away.

So the photos below are looking down on the top rail of the cab frame, with a tape measure stretched from one end to the other.

Click image for larger version

Name:	Pat 12 Cab Frame 003.jpg
Views:	4
Size:	77.4 KB
ID:	66090

The center of the top frame is at inch 26 the driver side hinge outside mounding bolt hole is 16 inches in from the end and the other 18 inches

Click image for larger version

Name:	Pat 12 Cab Frame 004.jpg
Views:	4
Size:	82.8 KB
ID:	66091 Click image for larger version

Name:	Pat 12 Cab Frame 005.jpg
Views:	4
Size:	80.5 KB
ID:	66092 Click image for larger version

Name:	Pat 12 Cab Frame 006.jpg
Views:	4
Size:	76.9 KB
ID:	66093 Click image for larger version

Name:	Pat 12 Cab Frame 007.jpg
Views:	3
Size:	72.8 KB
ID:	66094

Alex I hope this is of help, because otherwise these are probably the dullest photos I have ever posted, not photo contest stuff.

Cheers Phil
__________________
Phil Waterman
`41 C60L Pattern 12
`42 C60S Radio Pattern 13
`45 HUP
http://canadianmilitarypattern.com/
New e-mail Philip@canadianmilitarypattern.com
Reply With Quote