View Single Post
  #1355  
Old 23-06-14, 16:40
Tony Wheeler's Avatar
Tony Wheeler Tony Wheeler is offline
Registered User
 
Join Date: May 2012
Location: Yarra Junction VIC
Posts: 953
Default

I'm not quite following here. Why does the block need honing? It's a brand new block, it should already be hone finished to 3.1875 inch. That's what the pistons are designed for, they should fit straight in. Clearance should only be about 1 thou, they'll be sloppy if the bores are honed out further.

If the bores need resizing for some reason, then it should definitely be done professionally as Lynn says. However I don't see why it would be necessary.
__________________
One of the original Australian CMP hunters.
Reply With Quote