Hello Bob,
Obviously you have had the same thought as I did. I once gave consideration to one of those some time ago, but the girth is a little too small to pull off the effect. Also noticed, if I am correct, and have been looking at the right ones, that the intake/output tubes are centrally located to the muffler ends.
It's that time of year, when we get a few crumbs of our tax dollars back, if lucky! In my case, I have been doing 'Salary Sacrifice' for the full 12mths, and several months ago reduced my working week from 5 days down to only 4. These combined should get me a few quid (of my OWN money) back. I have been waiting for this annual event for a long time, because it is the only time I can afford such an expensive item as the custom made muffler. Assuming the reply to my enquiry proves cost is approximately same as their ebay listing of a very similar muffler, then I will give serious thought to ordering one. It should not be any more than approx $180 USD, including the postage.
I know its a lot of money. I just feel the muffler will be too visible to substitute one with different dimensions or tube locations.
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still)
Medium sized, half fake, artillery piece project. (The 1/4 Pounder)
|