Chevrolet 216 - engine bearings
Hi all,
I am currently working on a Chev 216 engine that someone has converted to shell main and big end bearings. Not sure of the makers of the shell bearings and do not have the numbers to hand.
What I am in need off is the machined size of the bearing locations in block and con rods (not journal sizes). This is for checking purposes.
Was there a GM instruction on doing this conversion or was it some aftermarket mod?
regards, Richard
__________________
Richard
1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2
Member of MVT, IMPS, MVG of NSW, KVE and AMVCS
KVE President & KVE News Editor
|